The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

Conclusions and recommendations

If there are no recommendations to be made because of the project, just call this section Conclusions.

The Conclusions section sums up the main element points buy essay online of one’s discussion, the essential attributes of your design, or perhaps the significant outcomes of your investigation. As its function is always to round the story off of any project, it should:

  • be written to relate right to the aims of the project as mentioned into the Introduction
  • indicate the extent to that the aims have already been achieved
  • summarise the key findings, outcomes or information in your report
  • acknowledge limitations and work out recommendations for future work (where applicable)
  • Highlight the usefulness or significance of the work.

The conclusions should relate with the aims of the work:

The purpose of this project would be to design a mobile phone tower for a suburban location..

The cell phone tower presented here may be erected safely in a suburban street.

It entails a complete part of no more than 2m 2 l, and it has the following safety features.

This investigation will review the quantity of passengers making use of the Monash University Clayton-Caulfield inter-campus bus in order to recommend adjustments into the service if required.

Analysis for the survey data obtained in this project indicates that usage of the Clayton-Caulfield inter-campus bus has grown by 24% in the past five years. It is strongly recommended that frequency be increased during peak usage.

The Conclusions section below is from a known level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Go through the buttons that are coloured look at comments.


Each one of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the discussion that is preceding. In this case, it indicates that the aims for the project have now been met. presented in this report fulfil the criteria specified when you look at the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this full case the important thing attributes of the designs – are then recapped. Incorporate piers that are round piled foundations, which are used because the soil conditions are unknown and perhaps unstable. Design 1, an easy composite I-girder bridge, gets the advantage of being made of steel and thus has longer spans and fewer piers.

Design 2, a super-T beam br >Design 2 Lecturer’s comment:
The significance of the results – in this case the final recommendation – is obviously stated. is therefore recommended. It offers Lecturer’s comment:
To finish off, the achievement for the project is reinforced. an affordable overpass with superior durability, and fully meets certain requirements regarding the design brief.

Always address limitations and suggest how they may be overcome in future work. The below that is excerpt from the Conclusions of a written report on a project investigating the end result of pulsation on heat transfer in horizontal pipe flow.

Experimental results Lecturer’s comment:
Key conclusions drawn through the project. indicated that pulsed flow without flow reversal had no effect that is significant with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. This really is likely due Lecturer’s comment:
Provide a explanation that is possible notable results, especially unexpected ones. towards the large disturbances when you look at the boundary that is hydrodynamic as soon as the flow changes direction. Further research Lecturer’s comment:
Recommend further research to handle any work that is extra think could be useful. is recommended to determine the utmost enhancement that is achievable.

It must be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations and/or solutions. the experimental results usually do not buy into the theoretical equations. This may be because of the deposits which developed within the pipe, or to inconsistent thermocouple temperature. Therefore, regular inspection of this test rig is preferred.

For a really long report, it really is acceptable to present the conclusions and recommendations in point form:

The prototype robot courier presented here has been confirmed to be capable of delivering documents autonomously in an working office environment. It offers demonstrated the next the different parts of mobile robotics:

  1. Localisation: The Kalman localisation that is filter-based achieved sub-centimeter accuracy under normal operating conditions.
  2. Environment modelling: The occupancy map was updated dynamically to add obstacles not within the map that is original.
  3. Path planning: A distance transform-based path planner using obstacle transforms produced a globally optimal local entrapment-free road to the target.

I commenti sono chiusi.